Remanufactured injector assembly, cross-ref 1465A439. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
1465A439 is supplied as a remanufactured replacement injector assembly. Cross-reference numbers: 1465A439. Application recorded for this part: Fits Mitsubishi — L200 Triton 4N15. An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge. Typical signs are poor starting hot or cold depending on whether the unit is weeping or sticking, an idle that hunts or sounds uneven, smoke under acceleration, and sometimes a smell of diesel in the oil where an injector is leaking internally. Before replacing anything, distinguish injector faults from their look-alikes. Comparing return volume between cylinders and running a cut-out test on a diagnostic tool will show which cylinder is actually contributing — cheap checks that prevent replacing parts that were not faulty. Fitment notes: injectors on the same engine wear together. Replacing only the failed unit often leaves the others close behind, and a single new injector reading differently from its neighbours will cause exactly the rough running you were trying to fix. Replacing as a matched set avoids that. Always fit new copper sealing washers and seals — used washers rarely seal a second time — and where the system requires injector classification or IQA codes, have them programmed to the ECU after fitting. Our rebuild standard: strip to components, clean, measure against wear limits, replace what is worn, machine back to specification where required, then calibrate and bench-test every unit. Delivery, return flow, opening pressure and leakage are recorded, and units outside specification are not dispatched. Test sheets available on request, and every unit carries a 12-month warranty.
| Part number | 1465A439 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Application | Fits Mitsubishi — L200 Triton 4N15 |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
