About this part
295900-0280 is supplied as a remanufactured replacement common rail injector. Cross-reference numbers: 295900-0280, 295900-0210, 3045023670-39455. Application recorded for this part: Fits Toyota — Hilux Euro.
An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge.
Typical signs are poor starting hot or cold depending on whether the unit is weeping or sticking, an idle that hunts or sounds uneven, smoke under acceleration, and sometimes a smell of diesel in the oil where an injector is leaking internally.
Because those symptoms also point to compression, turbocharger or air-side problems, it is worth confirming before ordering. A return-flow (back-leakage) test across all injectors and a cylinder cut-out test will usually identify both whether the fault is injector-related and which cylinder is responsible.
Fit as a matched set rather than singly — one new injector among worn neighbours reproduces the uneven running you set out to cure. New sealing washers every time, clean seats, correct torque, and where applicable, program the injector codes into the ECU once fitted.
Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
Specifications
| Part number | 295900-0280 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 295900-0280, 295900-0210, 3045023670-39455 |
| Application | Fits Toyota — Hilux Euro |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
Fitment note. Several part numbers in this family look similar. Confirm the number on your
existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo
and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.
