Remanufactured nozzle, cross-ref 23670-30030. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
23670-30030 is supplied as a remanufactured replacement nozzle. Cross-reference numbers: 23670-30030. Application recorded for this part: Fits Toyota — 2.5D 2KD. This part works at the sharp end of the injection system — high pressure, tight clearances, direct exposure to combustion heat. Nozzle condition governs how well fuel atomises, and therefore how much of it contributes to power rather than leaving as smoke. Watch for smoke on start-up, a rough idle that does not settle, wet or coked deposits around the tip, and consumption rising without any change in how the machine is worked. Confirm the diagnosis first: look for contamination elsewhere in the system and verify supply condition. A nozzle that cokes up again within weeks is a symptom of something else, not a defective nozzle. Assembly notes: strict cleanliness, new washers and seals, correct torque, and no re-use of old copper. Where the system uses coded injectors, enter the codes after fitting or the ECU cannot compensate correctly. Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
| Part number | 23670-30030 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Application | Fits Toyota — 2.5D 2KD |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
