Remanufactured nozzle, cross-ref 0414703007. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
0414703007 is supplied as a remanufactured replacement nozzle. Cross-reference numbers: 0414703007. This part works at the sharp end of the injection system — high pressure, tight clearances, direct exposure to combustion heat. Nozzle condition governs how well fuel atomises, and therefore how much of it contributes to power rather than leaving as smoke. Watch for smoke on start-up, a rough idle that does not settle, wet or coked deposits around the tip, and consumption rising without any change in how the machine is worked. Before ordering, check whether the fault really originates here. Poor spray often starts upstream — supply pressure, contamination, or a high-pressure pump no longer delivering — and replacing only the nozzle leaves the cause in place. Assembly notes: strict cleanliness, new washers and seals, correct torque, and no re-use of old copper. Where the system uses coded injectors, enter the codes after fitting or the ECU cannot compensate correctly. How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.
| Part number | 0414703007 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 0414703007 |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
