Remanufactured injector, cross-ref 61560080276, WD615. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
61560080276 is supplied as a remanufactured replacement injector. Cross-reference numbers: 61560080276, WD615. Application recorded for this part: Fits Weichai — WD10 WP10. The injector sits at the end of the rail and does the final metering work: it receives fuel already at high pressure and decides both how much enters the cylinder and how well atomised it is. That combination governs power, smoke and fuel consumption more directly than almost any other part on the engine. Watch for hard hot starting, uneven idle, visible smoke, a misfire that clears when the engine is revved, and consumption creeping up without any change in operating conditions. A back-leakage comparison across the set is the cheapest meaningful test: uneven return between cylinders points at the failing unit. Follow it with a cut-out test to confirm which cylinder actually stops contributing. Before fitting: clean the seat thoroughly, use new copper washers and seals, and torque the clamp to the engine manufacturer’s figure. Replace as a set where possible, and check whether the ECU needs the new units’ classification codes written in afterwards. Rebuild process: full teardown and measurement first, then replacement of all wear components, machining back to specification where required, followed by calibration and bench testing. The difference between this and a cleaned used part is the measurement and test record — we hold every unit to the specification for the part number, not just to 'it runs'. Test sheets available on request, and every unit ships with a 12-month warranty.
| Part number | 61560080276 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 61560080276, WD615 |
| Application | Fits Weichai — WD10 WP10 |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
