Remanufactured injector, cross-ref 02112645, 0432191379. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
02112645 is supplied as a remanufactured replacement injector. Cross-reference numbers: 02112645, 0432191379. Application recorded for this part: Fits Deutz. An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge. Watch for hard hot starting, uneven idle, visible smoke, a misfire that clears when the engine is revved, and consumption creeping up without any change in operating conditions. Because those symptoms also point to compression, turbocharger or air-side problems, it is worth confirming before ordering. A return-flow (back-leakage) test across all injectors and a cylinder cut-out test will usually identify both whether the fault is injector-related and which cylinder is responsible. Fitting notes: replace as a set rather than singly. A lone new injector will deliver differently from the worn ones around it, which usually reproduces the rough running. Use new sealing washers every time, clean the injector bore and seat carefully, and check whether your engine management expects classification codes to be entered after installation. How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.
| Part number | 02112645 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 02112645, 0432191379 |
| Application | Fits Deutz |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
