About this part
JX100 is supplied as a remanufactured replacement fuel injection part. Cross-reference numbers: JX100, JX110, 84534252. Application recorded for this part: CASE JX70 JX75 JX80 JX90 Farmall 110A 110M.
This is the last precision component in the fuel path. Everything upstream exists to deliver clean fuel at stable pressure; this unit decides when combustion starts and how completely the charge burns. That is why injector condition shows up so directly in noise, smoke and emissions.
Symptoms that point to injector wear include hard starting when hot, rough idle, white smoke at start-up or black smoke under load, a sharp knocking from one cylinder, increased fuel consumption and a gradual loss of power.
A back-leakage comparison across the set is the cheapest meaningful test: uneven return between cylinders points at the failing unit. Follow it with a cut-out test to confirm which cylinder actually stops contributing.
Installation notes: new copper washers and seals are mandatory, the seat must be clean and undamaged, and the retainers should be torqued to the engine manufacturer's specification. If the ECU stores injector codes for this engine, program them after fitting, otherwise the engine will not compensate correctly.
How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.
Specifications
| Part number | JX100 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | JX100, JX110, 84534252 |
| Application | CASE JX70 JX75 JX80 JX90 Farmall 110A 110M |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
Fitment note. Several part numbers in this family look similar. Confirm the number on your
existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo
and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.
