Remanufactured common rail injector, cross-ref 6710170121, A6710170121, EMBR00301D. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
6710170121 is supplied as a remanufactured replacement common rail injector. Cross-reference numbers: 6710170121, A6710170121, EMBR00301D. In a common rail system the injector is the component that actually controls combustion. It holds back fuel at rail pressure and lifts for only a few milliseconds at a time, metering the exact quantity and breaking it into a fine spray so the charge ignites cleanly. When delivery drifts, the engine does not usually stop — it simply starts to burn fuel badly. Watch for hard hot starting, uneven idle, visible smoke, a misfire that clears when the engine is revved, and consumption creeping up without any change in operating conditions. Because those symptoms also point to compression, turbocharger or air-side problems, it is worth confirming before ordering. A return-flow (back-leakage) test across all injectors and a cylinder cut-out test will usually identify both whether the fault is injector-related and which cylinder is responsible. Installation notes: new copper washers and seals are mandatory, the seat must be clean and undamaged, and the retainers should be torqued to the engine manufacturer's specification. If the ECU stores injector codes for this engine, program them after fitting, otherwise the engine will not compensate correctly. How we build it: the unit is fully disassembled, cleaned and measured, not simply resealed. Wear items — seals, springs, and where clearance is out of specification the plunger and barrel or nozzle assemblies — are replaced rather than reused. Sealing faces and bores are re-machined back to original clearances, then the unit is calibrated and run on a bench with delivery, return flow, opening pressure and leakage recorded. Anything outside specification does not ship. Test sheets for your specific units are available on request. Covered by a 12-month warranty.
| Part number | 6710170121 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 6710170121, A6710170121, EMBR00301D |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
