DIESEL FUEL INJECTION · REMANUFACTURED & AFTERMARKET
Get a Quote
HomeInjector › 4954647
Fuel Injection Part 4954647
Fuel Injection Part 4954647 view 1Fuel Injection Part 4954647 view 2Fuel Injection Part 4954647 view 3
Remanufactured

Fuel Injection Part 4954647 for Scania

Remanufactured fuel injection part, cross-ref 4954647, 4704357, 1516658. Bench-tested before shipment.

Cross-reference / interchange numbers

495464747043571516658
Condition
Remanufactured — not a genuine OEM new part
Warranty
12 months
Testing
Bench-tested: injection quantity, return flow, opening pressure, leakage
Application
Fits Scania — HPI
Request a Quote

Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.

About this part

4954647 is supplied as a remanufactured replacement fuel injection part. Cross-reference numbers: 4954647, 4704357, 1516658. Application recorded for this part: Fits Scania — HPI. In a common rail system the injector is the component that actually controls combustion. It holds back fuel at rail pressure and lifts for only a few milliseconds at a time, metering the exact quantity and breaking it into a fine spray so the charge ignites cleanly. When delivery drifts, the engine does not usually stop — it simply starts to burn fuel badly. What owners usually notice first: longer cranking, a rougher idle, more smoke than the engine used to produce, worse consumption, and occasionally a metallic knock that appears under load and clears once the engine is revved. Do a return-flow check before buying anything. Comparing leak-off volumes between cylinders takes minutes, and if one injector returns far more than its neighbours, that single test has answered the question. Before fitting: clean the seat thoroughly, use new copper washers and seals, and torque the clamp to the engine manufacturer’s figure. Replace as a set where possible, and check whether the ECU needs the new units’ classification codes written in afterwards. Our rebuild standard: strip to components, clean, measure against wear limits, replace what is worn, machine back to specification where required, then calibrate and bench-test every unit. Delivery, return flow, opening pressure and leakage are recorded, and units outside specification are not dispatched. Test sheets available on request, and every unit carries a 12-month warranty.

Specifications

Part number4954647
ConditionRemanufactured (not a genuine OEM new part)
Cross-reference4954647, 4704357, 1516658
ApplicationFits Scania — HPI
ProcessDisassembled, cleaned, measured, wear parts replaced, machined to specification
Bench testDelivery, return flow, opening pressure and leakage recorded before dispatch
Warranty12 months
Fitment note. Several part numbers in this family look similar. Confirm the number on your existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.

More part numbers for Scania

Related technical guides

Related part numbers