About this part
332X1021 is supplied as a remanufactured replacement fuel injection part. Cross-reference numbers: 332X1021, 322X1021BR, B416810387. Application recorded for this part: F00B.L0P.047.
An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge.
Symptoms that point to injector wear include hard starting when hot, rough idle, white smoke at start-up or black smoke under load, a sharp knocking from one cylinder, increased fuel consumption and a gradual loss of power.
Do a return-flow check before buying anything. Comparing leak-off volumes between cylinders takes minutes, and if one injector returns far more than its neighbours, that single test has answered the question.
Before fitting: clean the seat thoroughly, use new copper washers and seals, and torque the clamp to the engine manufacturer’s figure. Replace as a set where possible, and check whether the ECU needs the new units’ classification codes written in afterwards.
Rebuild process: full teardown and measurement first, then replacement of all wear components, machining back to specification where required, followed by calibration and bench testing. The difference between this and a cleaned used part is the measurement and test record — we hold every unit to the specification for the part number, not just to 'it runs'. Test sheets available on request, and every unit ships with a 12-month warranty.
Specifications
| Part number | 332X1021 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Cross-reference | 332X1021, 322X1021BR, B416810387 |
| Application | F00B.L0P.047 |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
Fitment note. Several part numbers in this family look similar. Confirm the number on your
existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo
and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.
