Remanufactured injector, cross-ref 0445116059. Bench-tested before shipment.
Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.
0445116059 is supplied as a remanufactured replacement injector. Cross-reference numbers: 0445116059. Application recorded for this part: Fits IVECO — 3.0D. An injector is a high-speed valve. It has to hold back rail pressure, then open and close within a fraction of a crankshaft degree — several times per cycle on pilot-injection engines. Anything that alters opening behaviour, whether it is carbon on the tip, a worn needle or a tired solenoid, changes how the cylinder burns its charge. What owners usually notice first: longer cranking, a rougher idle, more smoke than the engine used to produce, worse consumption, and occasionally a metallic knock that appears under load and clears once the engine is revved. A back-leakage comparison across the set is the cheapest meaningful test: uneven return between cylinders points at the failing unit. Follow it with a cut-out test to confirm which cylinder actually stops contributing. Before fitting: clean the seat thoroughly, use new copper washers and seals, and torque the clamp to the engine manufacturer’s figure. Replace as a set where possible, and check whether the ECU needs the new units’ classification codes written in afterwards. Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.
| Part number | 0445116059 |
| Condition | Remanufactured (not a genuine OEM new part) |
| Application | Fits IVECO — 3.0D |
| Process | Disassembled, cleaned, measured, wear parts replaced, machined to specification |
| Bench test | Delivery, return flow, opening pressure and leakage recorded before dispatch |
| Warranty | 12 months |
How to tell a failing common rail injector from compression, turbo and air-side faults — and why the cheap checks come first.
Read the guide →Three very different things are sold under similar descriptions. Here is what separates them, and what to ask before you buy.
Read the guide →What the digits on your injector actually mean, why several numbers fit the same part, and how to avoid ordering the wrong one.
Read the guide →
