DIESEL FUEL INJECTION · REMANUFACTURED & AFTERMARKET
Get a Quote
HomeFuel Pump › NT855
Fuel Injection Pump NT855
Fuel Injection Pump NT855 view 1
Remanufactured

Fuel Injection Pump NT855

Remanufactured fuel injection pump, cross-ref NT855, 3262175, K1001-D80D85. Bench-tested before shipment.

Cross-reference / interchange numbers

NT8553262175K1001-D80D85
Condition
Remanufactured — not a genuine OEM new part
Warranty
12 months
Testing
Bench-tested: injection quantity, return flow, opening pressure, leakage
Application
PT
Request a Quote

Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.

About this part

NT855 is supplied as a remanufactured replacement fuel injection pump. Cross-reference numbers: NT855, 3262175, K1001-D80D85. Application recorded for this part: PT. This unit sets both quantity and timing for every cylinder. Modern engines depend on that timing being accurate to well under a degree, so internal wear that would once have been tolerated now shows up as smoke, noise and failed emissions checks. Typical indicators are progressively harder starting, particularly when hot, reduced power, smoke under load, erratic idle, and fuel dilution in the sump — the last one should always be investigated immediately. Check supply pressure at the pump inlet and look for air in the clear line before assuming internal wear. Plenty of pumps get replaced for a blocked filter or a suction leak that costs a fraction to put right. Fitment notes: this unit must be timed to the engine, not simply bolted on. Never force the shaft to align — turn the engine over to meet it. Prime the system before cranking, fit a new drive seal where specified, and verify supply pressure from the lift pump before start-up. Running a dry pump, even briefly, causes damage that no warranty will cover. Rebuilt rather than refurbished: full teardown and measurement, worn components replaced instead of cleaned and reused, sealing surfaces restored to specification, then bench calibration and testing. The record is what separates this from a used part — we can provide the test sheet for your order. Covered by a 12-month warranty.

Specifications

Part numberNT855
ConditionRemanufactured (not a genuine OEM new part)
Cross-referenceNT855, 3262175, K1001-D80D85
ApplicationPT
ProcessDisassembled, cleaned, measured, wear parts replaced, machined to specification
Bench testDelivery, return flow, opening pressure and leakage recorded before dispatch
Warranty12 months
Fitment note. Several part numbers in this family look similar. Confirm the number on your existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.

Related technical guides

Related part numbers