DIESEL FUEL INJECTION · REMANUFACTURED & AFTERMARKET
Get a Quote
HomeFuel Pump › 0445025078
Fuel Injection Pump 0445025078
Fuel Injection Pump 0445025078 view 1
Remanufactured

Fuel Injection Pump 0445025078

Remanufactured fuel injection pump, cross-ref 0445025078. Bench-tested before shipment.

Cross-reference / interchange numbers

0445025078
Condition
Remanufactured — not a genuine OEM new part
Warranty
12 months
Testing
Bench-tested: injection quantity, return flow, opening pressure, leakage
Application
CB18
Request a Quote

Quote within 24 hours. Send a photo of your nameplate and we will confirm the exact match.

About this part

0445025078 is supplied as a remanufactured replacement fuel injection pump. Cross-reference numbers: 0445025078. Application recorded for this part: CB18. Every injection event depends on this pump producing pressure at exactly the right moment. Because it also carries its own lubrication, poor supply pressure and fuel dilution do disproportionate damage — which is why the supply side should always be checked alongside the pump itself. The pattern is normally cumulative: slightly harder starting, then noticeable power loss, then smoke and unstable idle. Where the drive seal has failed, diesel in the lubricating oil is the warning that should stop you running the engine. Before condemning the pump, rule out the cheap causes: supply restrictions, a weak lift pump, air ingress on the suction side and a blocked filter. Check supply pressure and condition at the pump inlet first, then look at delivery and timing. Installation notes: never rotate the pump by force to align it — bar the engine over instead. Prime before cranking, renew the drive seal, confirm supply pressure, and bleed the system properly. Dry running for even a few seconds is the most common cause of premature failure on an otherwise sound pump. Our rebuild standard: strip to components, clean, measure against wear limits, replace what is worn, machine back to specification where required, then calibrate and bench-test every unit. Delivery, return flow, opening pressure and leakage are recorded, and units outside specification are not dispatched. Test sheets available on request, and every unit carries a 12-month warranty.

Specifications

Part number0445025078
ConditionRemanufactured (not a genuine OEM new part)
ApplicationCB18
ProcessDisassembled, cleaned, measured, wear parts replaced, machined to specification
Bench testDelivery, return flow, opening pressure and leakage recorded before dispatch
Warranty12 months
Fitment note. Several part numbers in this family look similar. Confirm the number on your existing unit, the engine model and the machine or vehicle application before ordering. Send us a nameplate photo and we will verify the match before dispatch.
All manufacturer names, symbols and part numbers are used for identification and cross-reference purposes only. We are not an authorised distributor and are not affiliated with the original equipment manufacturer. Products offered are remanufactured or new aftermarket replacement parts unless stated otherwise.

Related technical guides

Related part numbers